1/7/2024 0 Comments Ntouch thermostatInstall the floor sensor in a conduit in the floor. ![]() The screen of the heating cable must be connected to the earth conductor of the power supply cable by using a separate connector. Connect the thermostat according to the attached diagram. Press your fingers under the side of the front part and pull towards you. Open the thermostat (make sure not to press on the display screen when removing the front).Route the conduit to the connection box and ensure the bending radius of the conduit is a minimum of 50 mm. It should be equally distant from the two heating cables by at least 2 cm. Place the floor sensor in a conduit in an appropriate place, where it is not exposed to sunlight or draft from door openings.Do not expose the thermostat to direct sunlight. ![]() The thermostat should not be placed on the inner side of a poorly insulated exterior wall, and should always be placed at least 50 cm from windows and doors, due to draft. It should never be placed in ‘wet zones’, and must be installed outside bathroom zone 2. The installation must be completed to local regulations and standards. The maximum room temperature should never be set above 35 degrees.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |